Front page | perl.perl5.porters |
Postings from July 2014
Smoke logs available at http://m-l.org/~perl/smoke/perl/linux/blead_g++_quick/log51b468f688a3660c4842b9e634c5fe58a2196307.log.gz
Automated smoke report for 5.21.3 patch 51b468f688a3660c4842b9e634c5fe58a2196307 v5.21.2-62-g51b468f
zwei: Intel(R) Core(TM) i7 CPU 920 @ 2.67GHz (GenuineIntel 2668MHz) (x86_64/8 cpu)
on linux - 3.13.0-32-generic [debian]
using g++ version 4.8.2
smoketime 17 minutes 25 seconds (average 4 minutes 21.250 seconds)
Summary: FAIL(m)
O = OK F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during: - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep
v5.21.2-62-g51b468f Configuration (common) -Accflags=-DPERL_POISON -Dcc=g++
----------- ---------------------------------------------------------
m m
m m -Duseithreads
| +--------- -DDEBUGGING
+----------- no debugging
Locally applied patches:
SMOKE51b468f688a3660c4842b9e634c5fe58a2196307
Testsuite was run only with 'harness'
Compiler messages(gcc):
caretx.c: In function ‘void Perl_set_caret_X()’:
caretx.c:102:9: error: ‘Ssize_t’ was not declared in this scope
caretx.c:102:17: error: expected ‘;’ before ‘len’
caretx.c:106:13: error: ‘len’ was not declared in this scope
caretx.c:116:13: error: ‘len’ was not declared in this scope
caretx.c:126:13: error: ‘len’ was not declared in this scope
vutil.c:36:1: warning: unused parameter ‘my_perl’ [-Wunused-parameter]
caretx.c: In function ‘void Perl_set_caret_X(PerlInterpreter*)’:
--
Report by Test::Smoke v1.53 build 1374 running on perl 5.18.2
(Reporter v0.050 / Smoker v0.045)