Front page | perl.perl5.porters |
Postings from September 2010
On Tue, Sep 7, 2010 at 6:21 AM, Nigel Horne <njh@bandsman.co.uk> wrote: > This comes as a pass - it's really a fail because nothing builds, I don't > know why. > >> Automated smoke report for 5.13.4 patch >> 90d1f214e03568148fd6495efac0f5614cfc0323 v5.13.4-162-g90d1f21 >> shredder: BePC (BePC/) >> on haiku - 1 >> using ? unknown cc version >> smoketime 2 seconds (average 2 seconds) >> >> Summary: PASS >> >> O = OK F = Failure(s), extended report at the bottom >> X = Failure(s) under TEST but not under harness >> ? = still running or test results not (yet) available >> Build failures during: - = unknown or N/A >> c = Configure, m = make, M = make (after miniperl), t = make test-prep >> >> v5.13.4-162-g90d1f21 Configuration (common) -Accflags="-O2 -Wall -pipe" >> ----------- --------------------------------------------------------- >> - - -Duseithreads >> | | | +----- PERLIO = perlio -DDEBUGGING >> | | +------- PERLIO = stdio -DDEBUGGING >> | +--------- PERLIO = perlio >> +----------- PERLIO = stdio >> >> >> Locally applied patches: >> uncommitted-changes >> SMOKE90d1f214e03568148fd6495efac0f5614cfc0323 >> >> Compiler messages(haiku): >> Configure .../boot/local/perl-current/UU/try.c: In function `main': >> /boot/local/perl-current/UU/try.c:31: warning: control reaches end of >> non-void function >> >> >> > > > It's looking like one of the Configure steps is failing and not continuing. Can you please try building that perl by hand and let us know at what step Configure is failing? Thanks! Steve Peters steve@fisharerojo.orgThread Previous | Thread Next