Hi, I found difficulties while installation of PERL. I found following error after running 'make test'. (make test is one of the command to be executed while installation) Failed 1 test script out of 190, 96.84% okay. ### Since not all tests were successful, you may want to run some ### of them individually and examine any diagnostic messages they ### produce. See the INSTALL document's section on "make test". ### If you are testing the compiler, then ignore this message ### and run ### ./perl harness ### in the directory ./t. ### ### Since most tests were successful, you have a good chance to ### get information with better granularity by running ### ./perl harness ### in directory ./t. u=0.32 s=0.3 cu=19.51 cs=7.79 scripts=185 tests=6506 *** Error code 1 make: Fatal error: Command failed for target `test' The end part of './perl harness' is as follows lib/tie-stdarray....ok lib/tie-stdpush.....ok lib/timelocal.......ok lib/trig............ok Failed Test Status Wstat Total Fail Failed List of failed ---------------------------------------------------------------------------- --- op/stat.t 58 1 1.72% 29 5 tests skipped, plus 14 subtests skipped. Failed 1/190 test scripts, 99.47% okay. 1/6506 subtests failed, 99.98% okay. # My Solaris7 operating system is installed with cc compiler. Machine is SPARC ULTRA 5. I would be thakful if you reply back with right solution. Thanking you in advance, Gajendra Chacharkar Company- NicheMusic.com 75 Arkansas Street San Francisco, USA zip- 94107 gajendrac@nichemusic.comThread Next