develooper Front page | perl.perl5.build | Postings from December 2007

Re: Put metaconfig sources under SVN on sourceforge

Thread Previous
From:
H.Merijn Brand
Date:
December 31, 2007 02:35
Subject:
Re: Put metaconfig sources under SVN on sourceforge
Message ID:
20071231113535.63904e37@pc09.procura.nl
On Thu, 24 Aug 2006 16:39:25 +0200, Raphael Manfredi
<Raphael_Manfredi@pobox.com> wrote:

> Hello perl5 builders,
> 
> I've revived the "dist" project since I've been using metaconfig and
> jmake on another project of mine for several years.
> 
> Ideally, I'd like to be able to retrofit some of the configuration
> knowledge gathered by having Configure run on as many platforms as
> possible.
> 
> The sources are available under subversion.  To access them, you
> can run the following:
> 
> 	svn co https://svn.sourceforge.net/svnroot/dist/trunk/dist

Is this still alive? I cannot access it.
metadist/metalint is broken under perl-5.10

> It would be good if the current maintainers of the metaconfig units
> for Perl could join the "dist" project.  I'll give you SVN write
> access.
> 
> I've also setup a mailing list "dist-svn@lists.sourceforge.net" where
> SVN commit messages along with patches will be sent.
> 
> Finally, I've created a #dist IRC channel on irc.freenode.net where
> commit messages will be automatically issued.

-- 
H.Merijn Brand         Amsterdam Perl Mongers (http://amsterdam.pm.org/)
using & porting perl 5.6.2, 5.8.x, 5.10.x  on HP-UX 10.20, 11.00, 11.11,
& 11.23, SuSE 10.1 & 10.2, AIX 5.2, and Cygwin.       http://qa.perl.org
http://mirrors.develooper.com/hpux/            http://www.test-smoke.org
                        http://www.goldmark.org/jeff/stupid-disclaimers/

Thread Previous


nntp.perl.org: Perl Programming lists via nntp and http.
Comments to Ask Bjørn Hansen at ask@perl.org | Group listing | About