develooper Front page | perl.daily-build.reports | Postings from January 2023

Smoke [blead] v5.37.8-13-gfa1fe46855 PASS linux5.18.18-200.fc36.x86_64 [Fedora Linux 37] (x86_64/1 cpu[8 cores]){blead_g++_quick}

From:
George Greer
Date:
January 24, 2023 07:57
Subject:
Smoke [blead] v5.37.8-13-gfa1fe46855 PASS linux5.18.18-200.fc36.x86_64 [Fedora Linux 37] (x86_64/1 cpu[8 cores]){blead_g++_quick}
Message ID:
202301240757.30O7vX6J2241853@vier.local
Smoke logs available at http://m-l.org/~perl/smoke/perl/x86_64-linux-thread-multi/blead_g++_quick/logfa1fe46855cd623ff0f787f3025c3c3f14cd57b4.log.gz

Automated smoke report for branch blead 5.37.9 patch fa1fe46855cd623ff0f787f3025c3c3f14cd57b4 v5.37.8-13-gfa1fe46855
vier.local: Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz (GenuineIntel 4676MHz) (x86_64/1 cpu[8 cores])
    on        linux - 5.18.18-200.fc36.x86_64 [Fedora Linux 37]
    using     ccache g++ version 12.2.1 20221121 (Red Hat 12.2.1-4)
    smoketime 1 hour 51 minutes (average 27 minutes 50 seconds)

Summary: PASS

O = OK  F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during:       - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep

v5.37.8-13-gfa1fe46855  Configuration (common) -Dcc="ccache g++"
----------- ---------------------------------------------------------
O O         
O O         -Duseithreads
| +--------- -DDEBUGGING
+----------- no debugging


Testsuite was run only with 'harness' and HARNESS_OPTIONS=j4

MANIFEST did not declare '.mailmap'
(See log because mailing list size limit is too small.)
Non-Fatal messages(gcc):

-- 
Report by Test::Smoke v1.72 running on perl 5.36.0
(Reporter v0.053 / Smoker v0.046)




nntp.perl.org: Perl Programming lists via nntp and http.
Comments to Ask Bjørn Hansen at ask@perl.org | Group listing | About