Front page | perl.daily-build.reports |
Postings from November 2022
Smoke logs available at http://m-l.org/~perl/smoke/perl/arm-linux-gnueabihf-thread-multi-64int/blead_gcc_quick/log2d0710deb09d8141e10a6e3a8d21f3d7f02f1523.log.gz
Automated smoke report for branch blead 5.37.6 patch 2d0710deb09d8141e10a6e3a8d21f3d7f02f1523 v5.37.4-343-g2d0710deb0
develpi.local: ARMv7 Processor rev 3 (v7l) (300 MHz) (armv7l/4 cpu)
on linux - 5.10.63-v7l+ [Raspbian GNU/Linux 10.13]
using ccache gcc version 8.3.0
smoketime 3 hours 11 minutes (average 47 minutes 50 seconds)
Summary: PASS
O = OK F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during: - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep
v5.37.4-343-g2d0710deb0 Configuration (common) -Dcc="ccache gcc"
----------- ---------------------------------------------------------
O O
O O -Duseithreads
| +--------- -DDEBUGGING
+----------- no debugging
Testsuite was run only with 'harness' and HARNESS_OPTIONS=j4
MANIFEST did not declare '.mailmap'
Compiler messages(gcc):
scope.c: In function ‘Perl_leave_scope’:
handy.h:99:35: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]
scope.c:1062:21: note: ‘a2.any_uv’ was declared here
scope.c:1062:21: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]
Non-Fatal messages(gcc):
--
Report by Test::Smoke v1.72 running on perl 5.28.1
(Reporter v0.053 / Smoker v0.046)