develooper Front page | perl.daily-build.reports | Postings from September 2022

Smoke [blead] v5.37.4-16-g1e78b5ed5d PASS linux5.18.18-200.fc36.x86_64 [Fedora Linux 36] (x86_64/1 cpu[8 cores]){blead_g++_quick}

From:
George Greer
Date:
September 22, 2022 17:28
Subject:
Smoke [blead] v5.37.4-16-g1e78b5ed5d PASS linux5.18.18-200.fc36.x86_64 [Fedora Linux 36] (x86_64/1 cpu[8 cores]){blead_g++_quick}
Message ID:
202209221728.28MHS3XU942394@vier.local
Smoke logs available at http://m-l.org/~perl/smoke/perl/x86_64-linux-thread-multi/blead_g++_quick/log1e78b5ed5d9d1161bfe209fff53163f270c40151.log.gz

Automated smoke report for branch blead 5.37.5 patch 1e78b5ed5d9d1161bfe209fff53163f270c40151 v5.37.4-16-g1e78b5ed5d
vier.local: Intel(R) Core(TM) i7-3820 CPU @ 3.60GHz (GenuineIntel 3702MHz) (x86_64/1 cpu[8 cores])
    on        linux - 5.18.18-200.fc36.x86_64 [Fedora Linux 36]
    using     ccache g++ version 12.2.1 20220819 (Red Hat 12.2.1-2)
    smoketime 1 hour 57 minutes (average 29 minutes 24 seconds)

Summary: PASS

O = OK  F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during:       - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep

v5.37.4-16-g1e78b5ed5d  Configuration (common) -Dcc="ccache g++"
----------- ---------------------------------------------------------
O O         
O O         -Duseithreads
| +--------- -DDEBUGGING
+----------- no debugging


Testsuite was run only with 'harness' and HARNESS_OPTIONS=j4

MANIFEST did not declare '.mailmap'
(See log because mailing list size limit is too small.)
Non-Fatal messages(gcc):

-- 
Report by Test::Smoke v1.72 running on perl 5.34.1
(Reporter v0.053 / Smoker v0.046)




nntp.perl.org: Perl Programming lists via nntp and http.
Comments to Ask Bjørn Hansen at ask@perl.org | Group listing | About