Front page | perl.datetime |
Postings from May 2012
Re: DateTime performance
Thread Previous
From:
Philipp K. Janert
Date:
May 4, 2012 07:11
Subject:
Re: DateTime performance
Message ID:
201205032123.23120.janert@ieee.org
On Thursday 03 May 2012 02:10:04 you wrote:
> On 2012.5.1 3:29 PM, Philipp K. Janert wrote:
> > However, when working through a files with a few
> > tens of millions of records, DateTime turns into a
> > REAL drag on performance.
> >
> > Is this expected behavior? And are there access
> > patterns that I can use to mitigate this effect?
> > (I tried to supply a time_zone explicitly, but that
> > does not seem to improve things significantly.)
>
> Unfortunately due to the way DateTime is architected it does a lot of
> precalculation upon object instantiation which is usually not used. So
> yes, it is expected in that sense.
Ok.
>
> If all you need is date objects with a sensible interface, try
> DateTimeX::Lite. It claims to replicate a good chunk of the DateTime
> interface in a fraction of the memory.
I'll check it out, thanks.
>
> Given how much time it takes to make a DateTime object, and your scale of
> tens of millions of records, you could cache DateTime objects for each
> timestamp and use clone() to get a new instance.
I considered that, but in reality, most of my timestamps
are actually different. (There are about 30M seconds in
a year, so I won't have much duplication, looking at 10-50M
records spread over a year...)
>
> sub get_datetime {
> my $timestamp = shift;
>
> state $cache = {};
>
> if( defined $cache->{$timestamp} ) {
> return $cache->{$timestamp}->clone;
> }
> else {
> $cache->{$timestamp} =
> make_datetime_from_timestamp($timestamp); return $cache->{$timestamp};
> }
> }
Thread Previous